Above-Roofline Chimney Removal
Lose the dead stack and restore a clean roofline that reads as original.
Learn moreA chimney you no longer use is prime wall and floor space frozen in place — and removing it cleanly opens up real design possibilities in the room. We take it out the way premium work demands: an engineered cap-to-footing teardown with load paths supported, contained interior demo, and finished wall and floor infill so the space reads as if the chimney was never there. The gas line is capped and pressure-tested, and you get a documented job package. You reclaim the room and forget it existed.
Some chimneys aren't worth saving. When total removal is the answer, our crew delivers it the way premium work should be done: a fully engineered teardown from cap to footing, every floor and wall it touched made flush and finished, the structure left as if the chimney had never existed. That masonry mass runs from the firebox and ash pit at the base up through the smoke chamber and flue to the crown — and it's frequently woven into floor framing, an exterior wall, or a fireplace breast carrying finish above it. Pull that out without a plan and you invite sagging floors and cracked drywall.
We work top-down and contained. The above-roof stack comes off and the roof is patched to an invisible standard; interior sections are dismantled under dust containment so soot and mortar don't drift through your living space; the firebox, throat, hearth slab, and ash pit are broken out cleanly. Below grade, where the scope calls for it, we excavate and break up the concrete footing so nothing interferes with future landscaping or an addition.
The finish is where craftsmanship shows. Once the masonry is gone, you're left with openings a careless crew would hand back as raw framing and a promise. We frame and drywall the chase, restore the wall plane flush, patch flooring where the hearth sat, and coordinate the texture and paint hand-off so the room reads as complete. If a gas appliance was involved, the supply is disconnected, permanently capped, and pressure-tested to verify a tight seal — never simply shut off and walked away from.
Expect a multi-day project scaled to chimney size, number of floors, and footing scope. Scaffold, roof anchors, and fall-protection go up front; a dumpster handles the rubble; reclaimed brick is salvaged on request; and the site is left swept. You receive a job package — photos of the framed infill, the gas pressure-test result where applicable, and the roof water-test — so the work is verifiable rather than merely trusted, and the removal is permitted and on the record.
At Space Fireplace Services, a full chimney removal to foundation is never guesswork. We scope every job from a graded, photographed inspection first — the NFPA 211 level the evidence calls for — so the work is matched to what your flue and masonry actually need, with the report to prove it. The documented inspection is the record the full chimney removal to foundation is built on.
Chimney inspectionMap the load paths and finish-bearing, then shore whatever needs support before demo begins.
The above-roof stack comes down and the roof is patched; interior demo happens under dust containment; the footing goes if it is in scope.
Disconnect any gas supply, cap it permanently at the branch, and pressure-test the cap.
Frame and drywall the chase flush, patch the flooring, coordinate the paint, and deliver the job package.
We've worked on 1,000+ DFW homes over 10+ years. Every job — small sweep or full rebuild — runs the same way: certified technicians, written quotes, photo reports, warranty in writing.
Load paths mapped and supported, with demolition sequenced so the house stays square
Interior demo kept contained, so soot and mortar never migrate through the home
Walls, floors, and chase framed, drywalled, and finished flush rather than left raw
The gas line permanently capped and pressure-tested, with a full documented job package
Family-owned, CSIA-certified, NFPA 211–compliant. We're the team you call when you want it done right the first time — no rotating subcontractors, no upsell pressure, no surprises. Same techs, same trucks, same standard.

Plan on a Level 1 inspection every year — that's the NFPA cadence — with an actual sweep once buildup reaches 1/8" of creosote. For a fireplace you light through the season, that usually lands at once a heating season. Think of it as the upkeep that keeps the centerpiece of the room clean, drawing well, and ready to look its best.
Yes. The inspectors who assess your chimney hold current CSIA (Chimney Safety Institute of America) certifications — you can confirm them in the CSIA member directory at csia.org — and our fireplace installations are handled by NFI specialists. The craft that makes a hearth a showpiece starts with the people standing in front of it.
Yes — emergency response is available 24/7 (subject to crew availability) for active water leaks, an animal trapped in the flue, post-fire damage, and storm damage, same-day in most cases. A fireplace is the heart of a room; when it's at risk, we treat it that way.
Always. You get a written quote before a single tool comes out, with photos of exactly what we found. Final pricing tracks the chimney's real condition and anything additional the inspection surfaces — no surprises, just a clear picture of what your fireplace needs.
Yes — our annual maintenance membership runs $19.99/month ($240/year) and covers a yearly Level 1 inspection and sweep ($248 value), priority scheduling, 10% off all repairs, and emergency-response priority. Cancel anytime, no contract. It's the quiet way to keep your hearth looking and working its best year after year.
Last reviewed:
Other services in the Removal & Decommission category.
Free written quote. Same-week scheduling. 24/7 emergency response when you need it.
Active leak, animal in flue, post-fire damage, or smoke event? Real humans on the line 7 AM to 12 AM every day — replies in under 2 minutes. Tech dispatch within 2 hours during business hours, subject to crew availability after-hours.
Emergency line