Wood-to-Gas Fireplace Conversion in Georgetown, TX
Imagine your wood-burning fireplace giving you real flames at the flip of a switch — same beautiful focal point, none of the hauling, ash, or cleanup that keeps you from using it. Converting wood to gas is an engineered project, not just "add a burner": we size or reline the flue for gas, lock the damper open to code, run a BTU-correct gas line with a sediment trap, pressure-test before flame, and verify with a CO check. You get a centerpiece you'll actually light on a Tuesday — with the safety done properly underneath. Serving Georgetown (5 ZIP codes, 75k residents) and surrounding neighborhoods with same-week scheduling.
Wood-to-Gas Fireplace Conversion in Georgetown
A wood-to-gas conversion turns your wood-burning fireplace into gas — a vented gas log set, a sealed direct-vent insert, or vent-free — handled as an engineered project rather than just "add a burner." The appliance swap is the simple part; the venting changes, code damper lock, gas line, and CO verification around it are what make the difference between a clean, lasting system and a hazard hiding behind a pretty flame.
Local dossier · Georgetown, TX
Georgetown's fireplaces come in two generations that couldn't be less alike. Around the courthouse square, Old Town Victorians and early-1900s cottages carry original chimneys patched by six owners across a century — beautiful surrounds, questionable flues, and dampers that gave up sealing during the Eisenhower administration. West of I-35, Sun City's thousands of single-story homes run the other direction: 1995-and-newer, gas-ready, low-maintenance by design, where the ask is usually cleaner logs, better burn media, or a surround that finally matches the rest of the house. We design differently for each. Old Town work is preservation-first — restore the surround, reline the flue in stainless, convert to gas quietly so the room keeps its age. Another patch on a patched flue isn't a fix, and we won't sell one. Sun City work is comfort-first — single-story attic access keeps vent runs simple, and swapping dated logs for a sealed insert usually takes a day and changes how often the fireplace actually gets lit. What we won't do anywhere in Georgetown is drop unvented logs into a tight den because it's the cheap route; vent-free is legal in Texas, but legal and advisable aren't synonyms. City permit, inspection, photo report — every job, both generations.
the Williamson County Courthouse
Why this matters in Georgetown
Georgetown pairs a beautifully preserved historic square with the sprawling Sun City retirement community and new growth. Historic masonry repointing meets prefab cap-and-chase work across one of Central Texas's oldest-and-newest mixes. The fireplace anchors the room here, and we keep it that way — sound beneath, sharp on the surface. That local stock is exactly why our Georgetown crews tailor wood-to-gas fireplace conversion to the homes here — not a generic checklist.
Common signs in Georgetown homes
- Tired of hauling firewood, ash, and cleanup
- Want real-fire ambiance with a wall switch
- You want that heat-losing open fireplace working as a real zone heater
- Your wood firebox is still sound, but you'd rather burn something cleaner
Wood-to-Gas Fireplace Conversion in Georgetown (Williamson County) — what's local
Georgetown sits in Williamson County (county seat: Georgetown). One of the fastest-growing counties in the US, built overwhelmingly with prefab-firebox new construction around a historic core in Georgetown. For wood-to-gas fireplace conversion that means our Georgetown crew sizes up the local housing stock before quoting — and follows Williamson County permit requirements for any work that needs an inspection sign-off.
Climate & code file · Greater Austin
Hill-Country reality this metro is written around: Central Texas fireplaces live on a different chemistry than the rest of the state. Local masonry leans on limestone and lime-based mortar that breathes and erodes differently than hard Portland mix; cedar (Ashe juniper) drops resinous needles and pollen onto caps and crowns and burns hot and fast in the firebox; flash-flood-grade downpours dump months of rain in an afternoon onto crowns and flashing that bake dry the rest of the year; and mild, short winters mean a flue may sit unused for ten months, then get lit hard for six weeks. Space Fireplace Services writes every Austin-metro recommendation against that cycle, so the centerpiece of the room stays sound, not against a generic template.
Limestone & lime mortar — the one that matters most
If your Georgetown chimney is older Hill-Country masonry, do not let a generalist repoint it with hard gray Portland. Soft limestone was laid in a breathable, high-lime mix that flexes with the stone; modern Portland is harder than the stone around it, so it transfers stress into the limestone and drives the cracking into the face — turning a repointing job into a stone-replacement job. We read the existing mortar, match its composition and color, and repoint so the repair moves with the wall through the heat-and-freeze cycle. That's the question budget crews don't even know to ask.
Cedar (Ashe juniper)
Cedar needles and the heavy December–February pollen pack into spark screens and crown washes — a clogged cap is a draft problem and a fire-screen failure at once. We clear and inspect the cap on every sweep. On wood-burners we also flag cedar's hot, fast, resin-heavy burn: it glazes a flue far quicker than seasoned oak, so a cedar-burning Georgetown home needs a tighter sweep interval, not the generic annual default.
Flash floods
Hill-Country rain doesn't drizzle — it arrives in inches-per-hour walls that test a crown and flashing seal the way ten dry months never do. The leak you didn't know you had announces itself in the first big storm, often as a stain a room away from where the water actually enters. We trace the true entry point with a moisture meter and controlled water test before recommending a fix — and we waterproof and re-flash before spring storm season, not after the ceiling stains.
Long dormancy
A Georgetown flue may sit unused for ten months, then get lit hard for six weeks — long enough for animals to nest, debris to collect, and a hairline crown crack to go unnoticed. A fall sweep-and-scan before the short burning season means your first cold-front fire is on a verified, clean, code-ready flue.
Code note · Greater Austin
Hill-Country code reality: soft limestone must be repointed in a breathable, high-lime mix — hard gray Portland is harder than the stone and drives the cracking into the face — and waterproofing belongs before the spring flash-flood season, not after the ceiling stains.
Built to code · Wood-to-Gas Fireplace Conversion in Georgetown
Wood-to-Gas Fireplace Conversion is held to published national standards no matter the city. Our Georgetown crew builds to these and documents the work; the locally-adopted code edition and permit requirements are confirmed with Williamson County's authority on every job.
- Damper permanently locked open — On a vented gas log conversion we permanently clamp the damper open or remove its plate entirely, so combustion products can never be trapped behind a closed damper above a live gas flame.
- Flue relined / sized for gas — Switch the fuel and you change the flue gas itself: its temperature, its volume, its acidity. That is why the masonry flue gets relined or downsized with a correctly-rated gas liner per NFPA 211, so it does not condense, corrode, or back-draft.
- Gas connection (NFPA 54) — Sizing the gas drop to the appliance BTU load comes first, then the NFPA 54 sediment trap and shutoff go in, and the line is pressure-tested by manometer before any flame.
- Sealed insert: positive connection — A sealed direct-vent insert gets a positive liner connection running from the appliance collar all the way to the cap; venting it into an open flue that condenses and back-drafts is never an option.
- CO check + ODS verification — Commissioning includes an ambient CO check with the unit operating, and if the conversion is vent-free, the oxygen-depletion-sensor (ODS) pilot is verified as well.
Scoped from a graded inspection
At Space Fireplace Services, a wood-to-gas fireplace conversion is never guesswork. We scope every job from a graded, photographed inspection first — the NFPA 211 level the evidence calls for — so the work is matched to what your flue and masonry actually need, with the report to prove it. The documented inspection is the record the wood-to-gas fireplace conversion is built on.
Chimney inspection in GeorgetownEvery wood-to-gas fireplace conversion in Georgetown
Deliverables
- Flue relined or downsized to suit gas so it drafts cleanly instead of condensing or back-drafting into the room
- For vented log sets, the code-required damper clamp locked open, or the plate removed entirely where that's the call
- A BTU-correct gas drop finished with a sediment trap, a shutoff, and a pressure test before the flame ever lights
- Ambient CO check + leak test at commissioning
How a job runs
Assess
Look over the firebox, the flue size, and where the gas can come from, then choose the right path.
Vent
Right-size the flue, relining or downsizing as needed, then lock the damper open to code.
Connect
Run a BTU-correct gas drop with a sediment trap and set the appliance.
Commission
Pressure-test, leak-test, and run an ambient CO check before we hand it over.
4+ neighborhoods in Georgetown
Same-week service across every neighborhood in Georgetown. Don't see yours? Call (469) 992-4912 — if it's in Georgetown, we cover it.
The Georgetown advantage.
Our Georgetown crew lives in the metro they serve, across Williamson County. They know which Georgetown neighborhoods — Sun City, Historic Square, Berry Creek and more — have crumbling crowns, and which newer builds skipped the cap. Local code knowledge, local referrals, local accountability for every wood-to-gas fireplace conversion.
More services in Georgetown
Wood-to-Gas Fireplace Conversion in nearby Williamson cities
We cover wood-to-gas fireplace conversion across Williamson County — same crew, same warranty. Nearby Georgetown cities we also serve:
Wood-to-Gas Fireplace Conversion in Georgetown — FAQ
I'd like to convert my wood fireplace to gas — what does that really involve?
A proper conversion is a sequence, not a burner swap. The flue gets sized or relined for gas, the damper gets locked open, which code requires for vented log sets, a BTU-correct gas line goes in with its sediment trap, and everything is pressure-tested before any flame. A CO check then confirms the room is safe to enjoy. That full chain is why the finished fireplace keeps performing instead of merely lighting.
Should I choose gas logs, a sealed insert, or electric?
Start with how you want the room to feel. Vented gas logs come closest to the character of a real open fire; a sealed direct-vent insert delivers the most heat and efficiency; electric asks nothing of you, no fuel, no maintenance. Our job is to fit the conversion to the way you will actually live with the room, not to steer you toward the biggest ticket.
If I'm switching to gas, why does the flue need work when the chimney's already there?
Your chimney was built around a wood fire, and gas is a different animal: different exhaust temperature, different volume, different acidity. Run gas up an oversized or mismatched flue and it condenses, corrodes, and back-drafts. Relining or downsizing to suit the new appliance is what keeps the conversion clean and safe, so it is never an optional line on the quote.
Can I convert back to wood later if I change my mind?
In many cases, yes, though it hinges on what your conversion involved. A removable log set walks back easily; a built-in sealed insert with a permanent liner does not. Before you commit, we spell out exactly how reversible your particular path is, so you choose with the full picture in front of you.
Is a vent-free gas conversion a good idea?
For the right space, it can be. Vent-free units run on an oxygen-depletion-sensor burner and need no chimney at all, which makes them appealing for supplemental heat. The trade-off is real, though: they release humidity and combustion products into the room itself. We are candid about where that works and where a vented or sealed unit serves the room better.
Our Old Town Georgetown chimney has been patched forever. What's the real fix?
A camera scope, then almost always a stainless steel liner sized to the appliance. Patching flue tile from the top has been the Old Town tradition for decades, and it fails because the cracks you can't see keep working. A continuous liner solves draft, seals the joints, and makes a gas conversion safe. One honest repair instead of a seventh hopeful one.
What's a sensible fireplace update in Sun City?
Swap the dated log set for a sealed gas insert with a remote and a thermostat. It's usually a one-day job in single-story stock, the heat actually stays in the room, and there's no wood to haul, ash to shovel, or damper to remember. For a lot of Sun City owners, that last part is the whole point.
Can we see vented and vent-free logs side by side before choosing?
Yes, and you should. Vented logs look like a real wood fire because they burn like one; vent-free logs keep all their heat in the room, but they put their combustion moisture there too, and we're choosy about where we'll install them. Ten minutes watching both burn makes the trade-offs obvious in a way no spec sheet does.
Do you serve all of Georgetown?
Yes — our crews cover Georgetown's 5 ZIP codes across Williamson County, including Sun City, Historic Square, Berry Creek, plus the surrounding communities.
How soon can you schedule wood-to-gas fireplace conversion in Georgetown?
We offer same-week scheduling across Georgetown, booked by a real person in under two minutes, 7 AM to midnight every day.
Why do Georgetown homes need wood-to-gas fireplace conversion?
Georgetown pairs a beautifully preserved historic square with the sprawling Sun City retirement community and new growth. Historic masonry repointing meets prefab cap-and-chase work across one of Central Texas's oldest-and-newest mixes. The fireplace anchors the room here, and we keep it that way — sound beneath, sharp on the surface. Wood-to-Gas Fireplace Conversion is part of keeping that local housing stock safe, efficient, and up to code.
How much does wood-to-gas fireplace conversion cost in Georgetown, TX?
Wood-to-Gas Fireplace Conversion in Georgetown starts from $2,250, but the honest number depends on what a craftsman finds on site — we won't quote premium work blind. A CSIA-certified technician inspects the actual condition, then hands you an itemized, transparent written quote tied to the findings and built to one national standard. No teaser pricing, no surprises. Call (469) 992-4912 for a free, no-pressure Georgetown quote.
Do you offer emergency or same-day wood-to-gas fireplace conversion in Georgetown?
Yes — we run same-week and emergency wood-to-gas fireplace conversion across Georgetown, scheduled by a real person 7 AM to midnight every day. For an active chimney hazard, call (469) 992-4912 and we prioritize Georgetown dispatch so a craftsman is on it fast.
Is there a CSIA-certified wood-to-gas fireplace conversion company near me in Georgetown?
Our Georgetown crew lives in and works the metro across Williamson County, including Sun City, Historic Square, Berry Creek — a certified, local wood-to-gas fireplace conversion team genuinely near you, holding the same national craftsmanship standard on every job, not dispatched cold from another city. Call (469) 992-4912.
Last reviewed:
Talk to a CSIA-certified expert today.
Free written quote. Same-week scheduling. 24/7 emergency response when you need it.
24/7 Response
Active leak, animal in flue, post-fire damage, or smoke event? Real humans on the line 7 AM to 12 AM every day — replies in under 2 minutes. Tech dispatch within 2 hours during business hours, subject to crew availability after-hours.
Emergency line