Chimney Framing Repair

On a factory-built or sided chimney, the cladding you see is wrapped around a wood chase — a framed box of studs, sheathing, and a structural cap that carries the flue and ties the whole assembly back to the house. Sound framing keeps the chimney plumb and attached. Let water in and the wood rots from the inside out, and the chase loses the strength holding everything in line. We approach that framing as a structural job, never a cosmetic one — because by the time a leaning chase is hurting the way the chimney looks, it has already been a safety problem for a while.

Rot is almost always a symptom, so we treat the cause alongside the damage. Water is entering somewhere — failed flashing, a cracked chase cover, a leaking cap, open trim joints — and swapping rotted studs without closing that path only buys a few seasons before the rot returns. Our technicians probe the framing to map how far it has spread, pin down the entry point, and stabilize the structure before any compromised member comes out. From there we cut back to sound wood and rebuild with treated, code-compliant lumber sized to carry the load it's actually meant to carry.

Since the chase is part of the building envelope, the job isn't done when the framing is back. We re-integrate the flashing, sheathing, and weather barrier so the wall sheds water as designed, then coordinate the siding, trim, and cap until the chimney is weather-tight and looks like it was never opened up. One crew owns the structure, the leak, and the finish, so you're not chasing a framer, a roofer, and a chimney company to close out a single problem.

It's the same structural-repair standard our craftsmen carry from our Dallas base to every job: find the water, prove the extent, rebuild to code, and weatherproof so the rot can't return. We photo-document the condition before and after, leaving you a clear record of what failed, what we replaced, and why the chimney is once again solidly — and visibly — tied to your home.