Blown-In Insulation in Boerne, TX

Cellulose runs about R-3.7 per inch and fiberglass about R-2.5 per inch, so hitting the same R-value target takes noticeably more inches of fiberglass than cellulose. Cellulose packs denser and resists air drifting through the blanket better, but it's heavier and settles more; loose-fill fiberglass is lighter, barely settles, and won't wick water if the attic leaks. We read each material's coverage chart and blow it to its own correct install depth, because inch-for-inch they are not interchangeable.

Because it settles after install, cellulose more than fiberglass, the depth on day one isn't the depth six weeks later. We install above the final R-target so that once the blanket settles, the SETTLED depth still meets spec. Blowing only to the target on day one leaves you short after settling, and that's one of the most common ways a loose-fill job quietly under-delivers.

No, and that's the key limit of the method. Loose fill is a conductive barrier, slowing heat as it moves through, but air still leaks straight past it at top-plate gaps, can lights, and penetrations. Blown over an unsealed attic it merely filters the leaking air. Air-sealing is a separate step that should come first; the blow handles conduction, not leakage.

Usually yes, as a top-off, as long as the existing layer is dry, intact, and neither moldy nor matted. Loose fill drapes right over old fill, and we blow the added depth to bring the total up to target. If the old layer is settled flat or crushed by foot traffic, we re-fluff or re-level it first, so the new fill isn't just resting on a dead, compressed base.

Loose fill's whole advantage is a seamless blanket that conforms around joists and wiring with no gaps, but only when it's installed to an even depth at the right machine density. Under-fluffed or thin-at-the-edges fill leaves cold spots. We dam the eaves, dial in the blower density, and staple depth-marker rulers across the deck, so the installed inches are a measurement you can read rather than a number we promise.

Not much. Nearly every unit we sell has a propane conversion or a factory propane spec — the differences live in orifices, regulators, and vent settings, not in the design catalog. What matters is doing the conversion by the book: Texas requires licensed gas fitters even in unincorporated Kendall County, and we document the whole setup in photos.

Honest answer: wood fits the architecture and gas fits the calendar. A masonry wood fireplace with a real stone chase is the Hill Country look, but it's a five-figure structure. A sealed gas unit inside a stone surround reads nearly the same for far less, and it gets lit ten times as often. Come watch both burn before deciding.

Yes, but placement is engineering, not preference. Hill Country evening wind rolls predictably, and an outdoor firebox facing the wrong way will push smoke at the seating no matter how pretty the stone is. We study orientation, firebox depth, and flue height against the roofline before drawing anything. Sometimes a fire pit is smarter — we'll say so.

Yes — our crews cover Boerne's 3 ZIP codes across Kendall County, including Hill Country Village, Esperanza, Cordillera Ranch, plus the surrounding communities.

We offer same-week scheduling across Boerne, booked by a real person in under two minutes, 7 AM to midnight every day.

Boerne is a historic Hill Country town in Kendall County — a German-rooted Main Street and luxury Cordillera Ranch estates. Period masonry repointing and clay-liner relining meet large custom-home fireplace work and rural spark-arrestor service. On every one, the hearth is the visual anchor of the living space — and we service it like one. Blown-In Insulation is part of keeping that local housing stock safe, efficient, and up to code.

Blown-In Insulation in Boerne starts from $1,600, but the honest number depends on what a craftsman finds on site — we won't quote premium work blind. A CSIA-certified technician inspects the actual condition, then hands you an itemized, transparent written quote tied to the findings and built to one national standard. No teaser pricing, no surprises. Call (469) 992-4912 for a free, no-pressure Boerne quote.

Yes — we run same-week and emergency blown-in insulation across Boerne, scheduled by a real person 7 AM to midnight every day. For an active chimney hazard, call (469) 992-4912 and we prioritize Boerne dispatch so a craftsman is on it fast.

Our Boerne crew lives in and works the metro across Kendall County, including Hill Country Village, Esperanza, Cordillera Ranch — a certified, local blown-in insulation team genuinely near you, holding the same national craftsmanship standard on every job, not dispatched cold from another city. Call (469) 992-4912.