Air Duct Services

There's a point past which a duct system isn't worth cleaning or sealing — it's worth replacing. Sagging crushed flex, undersized runs choking the system, contaminated fiberglass liner that can't be cleaned, ductwork so leaky and so wrong no amount of mastic will save it. We re-duct homes the way a premium contractor should: sized to Manual-D, built in durable materials, sealed and insulated correctly, and verified at the end. It's a craftsmanship job, and we treat it as one.

Here's why ducts fail and why patching eventually stops paying: builder-grade flex sags, tears, and collapses over a decade or two; runs undersized from day one build high static pressure that shortens equipment life and leaves rooms uncomfortable no matter what you do at the thermostat; and fiberglass-lined duct that's grown mold can't be returned to clean — it has to come out. When you're pouring repair after repair into a system that's fundamentally wrong, replacement is the honest answer, and we'll tell you when you've reached it rather than sell you another patch.

Our re-ductwork starts with design, not demolition. We measure the system — static pressure and, where it matters, a Manual-D right-sizing so the new runs genuinely match the equipment and the rooms. Then we build it properly: rigid round or spiral sheet-metal hard pipe where durability and low static loss matter, R-6/R-8 insulated flex where flexible runs make sense, fabricated sheet-metal or fiberglass-ductboard plenums, takeoffs and boots set and sealed, and the whole system strapped and supported to code spacing so nothing sags again. Every joint is sealed with mastic and UL-181 tape, every attic run insulated against loss and sweating. We convert failing flex to hard pipe, add or relocate supply runs to condition a hot or cold room or an addition, and resize a mis-sized system to fix the airflow and noise problems no thermostat ever could.

The Space Fireplace Services finish is verification and documentation. We commission the new system — static-pressure and airflow checks, a Duct-Blaster leakage test to prove the new ductwork is tight — and photo-document the build before insulation and drywall hide it. You're left with a record of a system engineered and installed to a standard, not a pile of flex stapled into an attic. On a high-end home that record matters at resale; on any home it's the line between comfort that lasts and a callback.

This hub spans full duct-system replacement and re-ductwork, flex-to-hard-pipe conversion, new supply-run and register additions for room add-ons, Manual-D right-sizing corrections, contaminated-liner removal and replacement, plenum-box fabrication and replacement, duct rerouting around remodels, and the duct insulation that finishes attic runs. It's the upgrade path for when cleaning (D1) and sealing (D2) can't save a system that's simply at the end of its life.

Because we work to a documented standard, a re-ductwork job is held to the same engineering and verification every time — sized, sealed, and tested the same on one job as the next. You're not hoping the installer knows Manual-D or owns a Duct-Blaster; you're buying the brand standard that earned its name on premium work. The premium is the engineering and the proof: a duct system that performs the day it's commissioned and stays that way.

If your ducts are failing rather than merely dirty, call (469) 992-4912 to book an engineered re-ductwork assessment.